Electrolux 85480 VI - Manual (Page 46)

Installation instructions
46
Water inlet hose with safety valve
After connecting the double-walled water inlet hose, the safety valve
is next to the tap. Therefore the water inlet hose is only under pressure
while the water is running. If the water inlet hose starts to leak during
this operation, the safety valve cuts off the running water.
Please take care when installing the water inlet hose:
- The electrical cable for the safety valve is in the double-walled
water inlet hose. Do not immerse the water inlet hose or the safety
valve in water.
- If water inlet hose or the safety valve is damaged, remove the mains
plug immediately.
- A water inlet hose with safety valve must only be replaced by a
specialist or by the Service Force Centre.
- Place the water inlet hose in such a way that it is never higher than
the bottom edge of the safety valve.
152955 32/0en 31-03-2005 9:04 Pagina 46