Electrolux 85480 VI - Manual (Page 30)

Operating instructions
30
NOTE: The start of the programme or the countdown of the delay
start will occur only after the closure of the door, until this
moment it is possible to modify the set made.
NOTE: Once the washing programme has started, a point-shaped
optical signal appears on the floor beneath the dishwasher’s door.
This optical signal will remain illuminated for all the duration of
the washing programme. If the appliance has been installed higher
up with a furniture door mounted flush, the optical signal will be
no longer visible.
5. To interrupt or cancel a washing programme
in progress
Interrupt or cancel a washing programme in progress ONLY
if it’s absolutely necessary.
Attention! Hot steam may escape when the door is opened.
Open the door carefully.
Interrupt a washing programme in progress
Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the point at which
it was interrupted.
Cancel a washing programme in progress
Open the dishwasher door.
Press simultaneously function buttons 2 and 3 for about 2
seconds, the indicator light of the button corresponding to the
running programme starts flashing.
After about 2 seconds the indicator lights of all the programme
buttons will illuminate, this means that the running programme
has been cancelled and that the machine has returned to setting
mode.
If a new washing programme is to be selected, check that there
is detergent in the detergent dispenser.
6. To cancel a delay start in progress
To cancel a delay start in progress you have to reset the dishwasher;
follow the same instructions given in "Cancel a washing
programme in progress".
Cancelling a delay start involves also the cancelling of the set
washing programme.
In this case you have to set the washing programme again.
152955 32/0en 31-03-2005 9:04 Pagina 30