Electrolux PRO STEAM TK SL5 E - Manual (Page 25)

Drying results unsatisfactory.
Wrong programme selected.
Select a different programme
the next time you dry (see “Pro-
gramme chart” chapter).
Lint filters clogged. Clean lint filters.
Fluff filter clogged. Clean fluff filter.
Heat exchanger clogged with
lint.
Clean heat exchanger.
Overloading of laundry.
Observe recommended loading
volumes.
Ventilation slots in base area
covered up. Uncover ventilation slots in base
area.
Residue on inside surface of
drum or drum ribs.
Clean inside surface of drum
and drum ribs.
Make an adjustment using the
Trockengrad (DRYNESS) func-
tion (see chapter ”Drying”)
Conductance of water at instal-
lation site differs from standard
setting of machine. Re-programme standard setting
for degree of drying (see ‘Pro-
gramming options’ chapter).
Loading door does not close.
Message on the display: Please
check if the door is closed prop-
erly and then press START.
Fine strainer not in place and/or
mesh filter not locked in place. Install fine strainer and/or snap
large mesh filter into place.
When a button is pressed - no
reaction of the machine.
Drying protection. After the start
of the programme, the option
can no longer be set. Turn the programme knob to
Aus (OFF). Set the programme
again.
Drum light does not work.
Programme selector in Aus
(OFF) position.
Turn programme selector to Be-
leuchtung (DRUM LIGHT) or to
any programme.
Defective light bulb.
Replace light bulb (see next sec-
tion).
Displayed programme time
changes erratically or stays un-
changed for a long time.
Programme time is corrected
automatically depending on
type and volume of laundry and
level of dampness.
Automatic process; this is not a
machine fault.
Programme inactive, massages:
The tank is full. Please empty it
and then press START or Please
empty the tank. are displayed.
Condensate tank is full.
Empty condensate tank, then
start programme with Start /
Pause button.
Drying cycle ends shortly after
programme starts. Finished
message is displayed. Not enough washing loaded or
washing loaded is too dry for se-
lected programme.
Select time programme or high-
er drying level (e.g. Schrank-
trocken (CUPBOARD DRY) in-
stead of Leichttrocken (DAMP)).
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends au-
tomatically (see „Drying cycle
complete ”).
Lint filter clogged. Clean lint filter.
Fluff filter clogged. Clean fluff filter.
Load volume too big. Reduce load volume.
Laundry insufficiently spun.
Laundry must be adequately
spun.
electrolux 25