Electrolux LAVAMAT TURBO L 12720 VIT - Manual (Page 47)

Set the machine
upright and
remove the two
remaining bolts
from the back.
Pull out the three
plastic spacers
from the holes
into which the bolts were fitted.
Plug the open holes with the plugs supplied with the instruction booklet.
You are advised to keep all transit devices so that they can be refitted if the
machine ever has to be transported again.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not impeded by
carpets, rugs etc.
• Before placing it on small tiles, apply a rubber coating.
• Never try to correct any unevenness in the floor by putting pieces of
wood, cardboard or similar materials under the machine.
• If it is impossible to avoid positioning the machine next to a gas
cooker or coal-burning stove, an insulating panel (85x57 cm) covered
with aluminium foil on the side facing the cooker or stove, must be
inserted between the two appliances;
• The machine must not be installed in rooms where the temperature
can drop below 0.
• The water inlet hose and the drain hose must not be kinked.
• Please ensure that when the appliance is installed, it is easily accessi-
ble for the engineer in the event of a breakdown.
Levelling
Carefully level by screwing the adjustable feet in or out. Never place
cardboard, wood or similar materials under
the machine to compensate for any
unevenness in the floor.
47
Installation
132984560.qxd 07/10/2005 19:07 Pagina 47