Eureka 3040 Series - Manual (Page 6)

Eureka Customer Service HELPLINE 1-800-282-2886 www.eureka.com 4
!
1) Pull up release handle latch and
remove dust cup compartment.
2) Unscrew the lens cover and remove
old bulb (Fig. 7).
3) Push in new bulb, replace lens cover
and screw. (Fig. 8).
4) Replace dust cup compartment,
snap release handle down to secure.
Change Light Bulb – Available on some models – Part number 57940-3
Make sure vacuum is turned off and power cord is unplugged.
1) Use handle release to lower handle
flat onto floor (Fig. 1).
Remove Brush Roll Cover
1) Remove 2 screws from the front
side of brush roll cover (Fig. 2).
2) Lift and remove brush roll cover
(Fig. 3).
Replace EXT-U Belt
1) Remove brush roll and belt.
2) Thread new belt around motor
shaft and brush roll (Fig. 4).
Replace Brush Roll
1) Insert left end of brush roll first.
Make sure square on brush roll
cap is in place.
2) Pull right side of brush roll to
stretch belt.
3) Secure right end cap into base
(Fig. 5).
4) Rotate brush roll 2 turns to
center belt.
5) Replace brush roll cover and
two screws (Fig. 6).
Replace EXT-U Belt if Worn, cut or Out of Shape – Part number 61120C
Motor can become hot with normal use.
Avoid touching the motor shaft when checking brush roll belt.
!
!
Fig. 2
Fig. 3 Fig. 4
Fig. 5 Fig. 6
Fig. 7 Fig. 8
Fig. 1
Maintain Brush Roll – Part number 77315
Do not remove end caps. Remove hair and threads from brush roll periodically.
How to Maintain Your Vacuum Cleaner
Make sure vacuum cleaner is turned off and power cord is unplugged.