beautypg.com

Important, Electrical requirements, Tools you will need – GE 6,000 BTU Window Room Air Conditioner Owners Guide User Manual

Page 9

background image

49-5000450 Rev. 2

9

Installation Instructions

INST

ALLA

TION INSTRUCTIONS

BEFORE YOU BEGIN

Read these instructions completely and carefully.

IMPORTANT –

Save these

instructions for local inspector’s use.

IMPORTANT –

Observe all

governing codes and ordinances.

Note to Installer

– Be sure to leave these

instructions with the Consumer.

Note to Consumer

– Keep these instructions for

future reference.

Skill level

– Installation of this appliance requires

basic mechanical skills.

• Completion

time

– Approximately 1 hour

We recommend that two people install
this product.

Proper installation is the responsibility
of the installer.

Product failure due to improper installation is not
covered under the Warranty.

‡

installation procedures as described in these
instructions when installing this air conditioner.

Questions? Visit our Website at: GEAppliances.com

ELECTRICAL REQUIREMENTS

These models require a 115/120-volt AC,
60-Hz grounded outlet protected with a
15-amp time-delay fuse or circuit breaker.

The 3-prong grounding plug minimizes the possibility
of electric shock hazard. If the wall outlet you plan to
use is only a 2-prong outlet, it is your responsibility
to have it replaced with a properly grounded 3-prong
wall outlet.

CAUTION

Do not, under any circumstances, cut or remove the
third (ground) prong from the power cord.

Do not change the plug on the power cord of this air
conditioner.

Aluminum house wiring may present special
problems—consult a qualified electrician.

Power cord includes a current interrupter device. A
test and reset button is provided on the plug case.
The device should be tested on a periodic basis
by first pressing the

TEST

button and then the

RESET

button while plugged into the outlet. If the

TEST

button does not trip or if the

RESET

button

will not stay engaged, discontinue use of the air
conditioner and contact a qualified service technician.

TOOLS YOU WILL NEED

Phillips head screwdriver

Ruler or tape measure

Pencil

Level

Scissors or knife

'ULOODQG´GULOOELW