Using the air conditioner – GE 6,000 BTU Window Room Air Conditioner Owners Guide User Manual
Page 6
6
49-5000450 Rev. 2
Using the Air Conditioner
Remote Control
Ŷ
To ensure proper operation, aim the remote control at the
signal receiver on the air conditioner.
Ŷ
The remote control signal has a range of up to 20 feet.
Ŷ
Make sure nothing is between the air conditioner and the
remote control that could block the signal.
Ŷ
Make sure batteries are fresh and installed correctly as
indicated on the remote control.
Do Not Operate in Freezing Outdoor Conditions
This cool-only air conditioner was not designed for freezing
outdoor conditions. It must not be used when the outdoor
temperature is below freezing (32°F).
Cool Mode
8VHWKH&RROPRGHDW
Low, Med, High
or
Speed
for
FRROLQJ8VHWKH
Temperature Increase
+
/
Decrease
–
pads to set the desired temperature between 64°F and
86°F in 1°F increments.
An electronic thermostat is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air will
become cooler. Set the thermostat at a higher number
and the indoor air will become warmer.
NOTE:
If the air conditioner is off and is then turned on
while set to a
Cool
setting or if turned from a fan setting
to a
Cool
setting, it may take approximately 3 minutes for
the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—
Select the
Cool
mode and
High
or
Med
fan with a middle set temperature.
For Maximum Cooling—
Select the
Cool
mode
and
High
fan with a lower set temperature.
For Quieter and Nighttime Cooling—
Select the
Cool
mode and
Low
fan with a middle set temperature.
Eco
Controls the fan.
ON—
The fan will cycle on and off with the compressor.
This may result in wider variations of room temperature
and humidity. NOTE: the fan may continue to run
for a short time or may pulse intermittently after the
compressor cycles off to sample the room air.
OFF—
The fan runs all the time, while the compressor
cycles on and off.
Fan Only Mode
8VHWKH)DQ2QO\0RGHDW/RZ0HGRU+LJKIDQVSHHG
to provide air circulation and filtering without cooling.
Since fan-only settings do not provide cooling, a Set
temperature cannot be entered. The room temperature
will appear in the display.
USING THE
AIR CONDITIONER