Electro-Voice EVID 6.2 - Manual (Page 2)

Architecture & Engineering Specs:
The loudspeaker shall be a two-way system consisting of two 6” (152mm)
low-frequency transducers, a 1” (25mm) high-frequency transducer with
a Coherent Coverage Waveguide, and a frequency-dividing network
installed in a vented, line-array enclosure. The network shall include a
passive limiter for both the low-frequency and high-frequency transducers.
The loudspeaker system shall meet the following performance criteria:
Power handling, 300-Watts of EIA RS-426A continuous pink noise (6 dB
crest factor); Frequency response, 62 Hz - 20 kHz (-10 dB from rated
sensitivity); Pressure sensitivity, 94 dB at one watt, 200 Hz -10 kHz at one
meter; Impedance, 8 ohms nominal, 6 ohms minimum. The high-frequency
transducer shall drive a waveguide to cover evenly 100° horizontally by
90° vertically. The enclosure shall be molded of acrylic butyl styrene. The
enclosure shall be 16.5” (419mm) high, 9” (228mm) wide, 11.75”
(298mm) deep. The finish shall be a paintable black or white. The grille
shall be zinc plated, powder coated for corrosion resistance, and
restrained with a safety leash. The loudspeaker shall be adjustable over
a range of 100° horizontally and 90° vertically. The support bracket shall
be low profile and integral with the enclosure. The system shall be weather
resistant to MIL Spec 810 and IEC 529 IP 34 test conditions. The surface
mount loudspeaker shall be the Electro-Voice® EVID model 6.2.
U.S.A. and Canada only. For customer orders, contact Customer Service at:
800/392-3497 Fax: 800/955-6831
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
+ 49 9421-706 0 Fax: + 49 9421-706 265
Other International locations. For customer orders, contact Customer Service at:
+ 1 952 884-4051 Fax: + 1 952 887-9212
For warranty repair or service information, contact the Service Repair department at:
800/685-2606
For technical assistance, contact Technical Support at: 866/78AUDIO
Specifications subject to change without notice.
12000 Portland Avenue South, Burnsville, MN 55337
Phone: 952/884-4051, Fax: 952/884-0043
www.electrovoice.com
© Telex Communications, Inc. 12/2005
Part Number 38109-983 Rev E
Beamwidth:
Frequency Response:
Directivity:
Block Diagram:
Side
Wall Plate
Front
Top
Performance Match:
• EVID 12.1 Sub
Available Accessories:
• VS-6 Vertical Mount Desk Stand for 6.2
• AB-ZE Array Bracket Kit for 2 or 4 ZX1i or EVID Systems, Black
• TC-6B Black Weatherized Terminal Cover for 6.2
• TC-6W White Weatherized Terminal Cover for 6.2
EVID 6.2 Part Numbers:
301047-001 Black
301047-002 White
301047-003 Black, Transformer
301047-004 White, Transformer
INPUT
LPF
HPF
Passive
Limiter +
Dimension Drawings: