Emerson EWR10D4 - Manual (Page 9)

Functional overview (cont’d)
Before you start
Recor
ding
Pla
ying discs
Editing
Bef
or
e y
ou star
t
Connections
Getting star
ted
Changing the SETUP men
u
Others
Español
9
Using a remote control
Keep in mind the following when using the remote
control:
• Make sure that there is no obstacle between the
remote control and the remote sensor on the
DVD recorder.
• Use within the operating range and angle as
shown.
• Remote operation may become unreliable if strong
sunlight or fluorescent light is shining on the
remote sensor of the DVD recorder.
• Remote control for different devices can interfere
with each other. Avoid using remote control for
other equipment located close to the DVD
recorder.
• Replace the batteries when you notice a fall off in
the operating range of the remote control.
POW ER DISP LAY
REC SPE ED CLE AR
CM SK IP SK IP
REC PAU SE
P
ENTE R
RE C MO NIT OR OPEN /CLO SE
TIME R PRO G.
ME NU PLA Y L IST
TO P M EN U/ OR IG INA L
SPA CE
1 2 3 4 5 6 7 8 9 0 k
A
K FW D g STO P C PL AY B RE V h H G
CH .@/: ABC DEF GHI JKL MNO PQR S TUV WXY Z
Remote
control
60˚
Within about
23feet (7m)
Installing batteries in the remote control
Install two AA batteries (supplied) matching the
polarity indicated inside battery compartment of the
remote control.
2
1
3
Note:
Incorrect use of batteries can result in hazards such
as leakage and bursting. Please observe the following:
• Do not mix new and old batteries together.
• Do not use different kinds of battery together,
although they may look similar, different batteries
may have different voltages.
• Make sure that the plus and minus ends of each
battery match the indications in the battery com-
partment.
• Remove batteries from equipment that is not going
to be used for a month or more.
• When disposing of used batteries, please comply
with governmental regulations or environmental
public instruction's rules that apply in your country
or area.
• Do not recharge, short-circuit, heat, burn or disas-
semble batteries.