Sharp 1.5 Cu. Ft. Countertop Microwave Oven Installation Guide for Trim Kit - Manual (Page 3)

E 3
STEP 3 SURFACE INSTALLATION
E. Carefully turn over exhaust assembly. Remove adhesive
backing from CUSHION L. The cushion should be applied
to the flanges of the duct assembly as indicated by
arrows. See Figure 5A.
CUSHION L
Figure 5A
F. Remove SCREW from the upper right and left corners at
the rear of the oven. Place duct assembly on the top of
the unit as shown and secure the duct assembly to the
oven using the two screws just removed from the oven.
See Figure 5B.
SCREW
SCREW
Figure 5B
A. BOTTOM DUCT ASSEMBLY: Place the Bottom duct in the
center of the opening so that gap "A" is equal to gap "B".
When the Bottom Duct assembly is positioned properly,
the front edge of the duct will be flush with the front of the
cabinet. Secure with 2 SCREWS (H) See Figure 6.
GAP "A"
NOTE:
CENTER BOTTOM
DUCT ASSEMBLY IN
THE OPENING
DETAIL A
GAP "B"
BOTTOM DUCT ASSEMBLY
SCREW (H)
Figure 6
B. CABINET INSTALLATION: Place the oven adjacent to
the wall or cabinet opening. Plug the power cord into the
electrical outlet. Carefully guide the assembled oven into
the prepared opening. Slide the oven on the Bottom Duct
assembly. See Figure 7.
Figure 7