Wolf E Series 30 Inch Built-in Microwave Oven Drop Down Door Installation Guide - Manual (Page 7)

wolfappliance.com | 7
Installation
1 Turn power off to the electrical outlet.
2 Move the unit near the opening. Remove and recycle
packing materials.
3 The unit is shipped with two shipping brackets located
on each side, behind the front face. Remove both
brackets, then reinstall screws. Refer to the illustration
below.
4 Plug the power cord into the grounded outlet.
5 Position the microwave oven in the opening and slide
back until the mounting flange is flush with the face of
the cabinet. Avoid pinching the power cord between the
unit and cabinet wall.
6 Open the door. Using the two holes on either side of the
mounting flange as a template, drill pilot holes into the
cabinet using a
1 /
16
" drill bit.
7 Mount the microwave oven using four screws provided.
Refer to the illustration below.
8 Turn power back on to the electrical outlet.
Troubleshooting
IMPORTANT NOTE: If the drop down door microwave oven
does not operate properly, follow these troubleshooting
steps:
• Verify electrical power is supplied to the microwave
oven.
• Verify proper electrical connections.
• If the microwave oven does not operate properly, contact
Wolf factory certified service. Do not attempt to repair
the oven. Wolf is not responsible for service required to
correct a faulty installation.
INSTALLATION
Wolf, Wolf & Design, Wolf Gourmet, W & Design and the color red as applied to knobs are registered trademarks and service marks of Wolf Appliance, Inc. Sub-Zero,
Sub-Zero & Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, and Ingredients are registered trademarks and service marks
of Sub-Zero, Inc. All other trademarks or registered trademarks are property of their respective owners in the United States and other countries.
REMOVE
BRACKETS
THEN REINSTALL
SCREWS
MOUNTING
SCREWS
Shipping brackets.
Mounting screws.