KITCHENAID 27 Inch Built-in Microwave Oven Owners Guide - Manual (Page 9)

9
Install Microwave Oven
1. Using 2 or more people, lift the microwave oven partially into
the cabinet cutout. If a spacer kit has been installed, lift the
microwave oven over it and position the microwave oven
between the guide strips.
A. Spacer bar flange
B. Spacer bar
C. Microwave oven
2. Push against the front frame of the microwave oven to insert
oven into cabinet. Push microwave oven completely into
cabinet and center in cabinet cutout.
NOTE: Open microwave oven door and push against seal
area of microwave oven front frame when pushing microwave
oven into cabinet. Do not push against outside edges.
3. Using an 1/8" (3.2 mm) drill bit, predrill pilot holes through the
mounting rails on each side of the microwave oven.
4. Securely fasten microwave oven to cabinet using two 3/4"
pan-head screws provided. Insert the screws through holes in
mounting rails. Do not overtighten screws.
A. Mounting rail
B. Truss-head screws
5. Replace convection grid, turntable, and support hub.
6. Reconnect power.
7. Display panel will light briefly and the clock should appear in
the display.
8. If display panel does not light, please reference the “Online
Ordering Information” section of the Quick Start Guide or
contact the dealer from whom you purchased your microwave
oven.
Complete Installation
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
Check Operation of Microwave Oven
1. Fill a microwave-safe container with 1 cup (250 mL) of water
and place container on the turntable inside the microwave
oven. Close door firmly.
2. Touch COOK.
3. Set power level, temperature, and cook time to “2:00” minutes.
4. Press START.
If microwave oven does not operate, check the following:
� Household fuse is intact and tight or circuit breaker has not
tripped.
� Electrical supply is connected.
� See the online “Troubleshooting”.
When the display reads “1:00” minute, open the microwave
oven door. The microwave oven should stop cooking. Close
door firmly. The interior microwave oven light should turn off.
5. Touch START to resume a preset cycle. The microwave oven
should begin cooking and the microwave oven interior light
should be ON.
Let microwave oven complete cooking time. Tones will sound
at the end of the cooking time and the microwave oven will
shut off.
6. Open microwave oven door and slowly remove container.
Water in container should be hot.
7. To set the clock and other microwave oven functions, refer to
the Quick Start Guide.
If you need Assistance or Service:
Please reference the “Online Ordering Information” section of the
Quick Start Guide or contact the dealer from whom you purchased
your built-in microwave oven.