How to assemble and use – Eureka 6900 User Manual
Page 7
How to Assemble and Use
POWER-TOUCH
®
Handle
Remote ON/OFF Selector for bare floor or carpet
Carpet – push down on front
*Off – middle
Bare Floor – push down on back
*Power ON/OFF can be controlled on some models from the
POWER-TOUCH handle switch or canister ON/OFF switch.
Other models can only use the canister switch.
Remote Speed Control (optional)
Regardless of the speed of the canister motor, slide to reduce or
increase power as needed.
Vacuum Control
Cleaning suction is reduced by pushing lever
to LOW position. Place lever at HIGH
position to increase suction for carpet
cleaning.
Available on models without Remote
Speed Control.
1. Push interlocking wands together.
2. Push assembled wands into power nozzle.
3. Place Power-Touch hose handle into wands until plug connects
and button locks.
4. Insert hose coupling into top of canister.
5. Push hose power cord into receptacle located near the canister
handle.
6. Pull on electrical cord and push plug into outlet. To rewind,
step on Cordaway cord reel button, hold and guide plug while
it rewinds.
7. Step on motorized nozzle to release handle; pull back to
comfortable work position.
8. Push On/Off canister switch.
(A thermostat automatically shuts off the motor if it overheats,
see Automatic Motor Shut-Off,)
9. Bare floor or carpet cleaning selection on remote control, only.
10. Variable Speed Control on the canister slides to increase or
decrease power as needed.
7
Carpet
Off
Bare Floor
Select bare floor or
carpet cleaning
n
Handle
Release
k
n
Power-Touch
Hose Handle
k
s
NOTE:
Optional remote controls on the hose handle operate
only if the canister switch is on.
3
1
2
4
9
8
5
6
7
10