Eureka 6900 - Manual (Page 6)

How to Assemble and Use
POWER-TOUCH ® Handle
Remote ON/OFF Selector for bare floor or carpet
*Off – push down on front
Bare Floor – push down on back
*Power ON/OFF can be controlled on some models from the
POWER-TOUCH handle switch or canister ON/OFF switch.
Other models can only use the canister switch.
Vacuum Control
Cleaning suction is reduced by
pushing lever to LOW position.
Place lever at HIGH position to
increase suction for carpet
cleaning.
Available on models without
Remote Speed Control.
1. Snap interlocking wands together.
2. Push assembled wands into power nozzle.
3. Push motorized nozzle plug into the retainer located at the
top of the upper wand; secure cord in slot (Detail A).
4. Place Power-Touch hose handle into wands until plug
connects and button locks.
5. Insert hose coupling into top of canister and push hose
power cord into receptacle located near the canister handle.
6. Pull on electrical cord and push plug into outlet. To rewind,
step on Cordaway cord reel button, hold and guide plug
while it rewinds.
7. Step on motorized nozzle to release handle; pull back to
comfortable work position.
8. Push On/Off canister switch.
(A thermostat automatically shuts off the motor if it
overheats, see Automatic Motor Shut-Off,)
9. Bare floor or carpet cleaning selection on remote control,
only.
6
ON
Select bare floor or
carpet cleaning
Detail A
Handle Release k
k
Power-Touch
Hose Handle k
NOTE: Optional remote controls on the hose handle
operate only if the canister switch is on.
s
O
F
F
3
1
2
4
9
8
5
6
7