How to use – Eureka 790 User Manual

Page 6

HOW TO USE

CORD
STORAGE
HOOKS

CORD
RETAINER

HANDLE
COLLAPSE
BUTTON

RESET
BUTTON

HANDLE
RELEASE
PEDAL

RESET
LIGHT

Cord Retainer

When preparing to use vacuum,
firmly push the electrical cord
down into the cord retainer. This
will place the electrical cord out
of the way while you vacuum.

Handle Collapse Button

To collapse the handle from the
upright position, press handle
collapse button, rotate handle
down until latch in hand grip
locks onto the body.

Cord Storage Hooks

This unit has two convenient
cord storage hooks attached
to the handle. Wind the cord
around the hooks and fasten
the plug to the cord to prevent
unwinding.

Handle Release Pedal

The handle release pedal is located next to the floor between
the two wheels on the back of the cleaner. Step on the handle
release pedal and pull back handle to find a comfortable
operating position. Handle will automatically lock into storage
position when handle is rotated into upright position.

Reset Button

This unit uses a cogged, non-stretch belt. If a large object causes
the brush roll to jam, the brush roll motor shuts off and the Reset
Light illuminates. Turn off and unplug the unit. Check the brush roll
for debris and clean if needed. Press the reset button, plug in the
unit and turn on to continue cleaning.

Reset Light

The reset light is a neon light that illuminates when the brush roll
jams. See reset button above for actions to take when this light comes
on.

Removable Exhaust Grille

Remove this exhaust grille to clean or replace filter. Refer to page 9.

REMOVABLE
EXHAUST GRILLE