Elmo Visual Presenter EV-200 - Manual (Page 12)

- 11 -
2-1 SETTING UP
OPEN OPEN
STAGE
STAGE
OPEN OPEN
STAGE
STAGE
AC adaptor
Video cable
2. SETTING UP AND STORING
Latch parts
Make sure that the power switch [POWER] is
OFF, and then remove all cords connected to
the Presenter.
Move the camera head to be in line with the
arm horizontally.
House the auxiliary stage inside the main
stage, and then fold the main stage. At this
time, house the accessory case inside the stage.
Note: - Confirm that the accessory
case is closed firmly before
housing.
Make sure that all movable parts are put
back to storing position accordingly.
Convex
part of the
arm side
Convex part
of the base unit
Convex part
of the main
stage side
Concave part of
the main stage
2-2 STORING
Gently release the clipped area (as marked
with arrow) of the right and left stages as
illustrated.
Note:- It may be damaged by un-
latching the stages putting
hands on other position not
shown by arrows.
- When the accessory case is
housed inside, be careful not to
drop it.
Connect the Composit-Video-out terminal
[VIDEO OUTPUT] of the Presenter to the
monitor TV with the Video cable (supplied).
Note: - Before starting connection, turn
OFF the power supply to each unit.
Connect the AC adaptor, and turn the power
switch [POWER] to ON.
Instruction for location:
- Please note that the image may be
affected by unsightly shadows caused
from other lights in the room or from the
outside. This effect can usually be
eliminated or reduced by repositioning
the EV-200.