beautypg.com

Important safety information – Empire Comfort Systems VFD26F User Manual

Page 3

background image

Page 3

23466-0-0407

When used without adequate combustion and ventilation air,

heater may give off CARBON MONOXIDE, an odorless,

poisonous gas.

Do not install heater until all necessary provisions are

made for combustion and ventilation air. Consult the writ-

ten instructions provided with the heater for information

concerning combustion and ventilation air. In the absence

of instructions, refer to the National Fuel Gas Code, ANSI

Z223.1, Section 5.3 or applicable local codes.

This heater is equipped with a PILOT LIGHT SAFETY

SYSTEM designed to turn off the heater if not enough fresh

air is available.

DO NOT TAMPER WITH PILOT LIGHT SAFETY

SYSTEM!

If heater shuts off, do not relight until you provide fresh air.
If heater keeps shutting off, have it serviced. Keep burner and

control compartment clean.

CARBON MONOXIDE POISONING MAY LEAD TO

DEATH.

Early signs of carbon monoxide poisoning resemble the flu,

with headache, dizziness and/or nausea. If you have these signs,

heater may not be working properly. Get fresh air at once!

Have heater serviced.
Some people — pregnant women, persons with heart or lung

disease, anemia, those under the influence of alcohol , those at

high altitudes — are more affected by carbon monoxide than

others.
The pilot light safety system senses the depletion of oxygen at its

location. If this heater is installed in a structure having a high

vertical dimension, the possibility exists that the oxygen supply

at the higher levels will be less than that at the heater. In this type

of application, a fan to circulate the structure air will minimize

this effect. The use of this fan will also improve the comfort level

in the structure. When a fan is used to circulate air, it should be

located so that the air flow is not directed at the burner.

WARNING

• An unvented room heater having an input rating of

more than 6,000 Btu per hour shall not be installed in a

bathroom.

• An unvented room heater having an input rating of

more than 10,000 Btu per hour shall not be installed in

a bedroom or bathroom.

• Due to high temperatures, the appliance should be located

out of traffic and away from furniture and draperies.

• Children and adults should be alerted to the hazard of

high surface temperature and should stay away to avoid

burns or clothing ignition.

• Young children should be carefully supervised when they

are in the same room with the appliance.

• Do not place clothing or other flammable material on or

near the appliance.

• Installation and repair should be done by a QUALIFIED

SERVICE PERSON. This appliance should be inspected

before use and at least annually by a professional service

person. More frequent cleaning may be required due to

excessive lint from carpeting, bedding materials, etc. It

is imperative that control compartments, burners and

circulating air passageways of the appliance be kept

clean.

• DO NOT use this fireplace if any part has been under

water. Immediately call a qualified service technician

to inspect the fireplace and to replace any part of the

control system and any gas control which has been under

water.

• You must operate fireplace with fireplace screen closed in

place. Do not close glass doors while operating heater.

• Do not place trash, logs or other articles on the log set

during operation.

• During manufacturing, fabricating and shipping, various

components of this appliance are treated with certain

oils, films or bonding agents. These bonding agents are

not harmful but may produce annoying smoke and

smells as they are burned off during initial operation of

the appliance. This is a normal temporary occurrence.

A window should be opened during the initial bake out

period.

• Correct installation of the ceramic fiber logs, proper

location of the fireplace and annual cleaning are necessary

to avoid potential problems with sooting. Sooting, resulting

from improper installation or operation, can settle on

surfaces outside the fireplace. See instructions for proper

installation.

• WARNING: Do not allow fans to blow directly into

the fireplace. Avoid any drafts that alter burner flame

patterns.

• WARNING: Do not use a blower insert, heat exchanger

insert or other accessory not approved for use with this

heater.

• WARNING! This fireplace needs fresh air for ventilation

to operate properly. This fireplace has an ODS (oxygen

depletion sensor) which will shut off the fireplace if

adequate fresh air is not available.

• Keep appliance area clear and free from combustible

materials, gasoline and other flammable vapors and

liquids.

THIS IS A HEATING APPLIANCE

IMPORTANT SAFETY INFORMATION

This manual is related to the following products: