Enviro FOCUS EG31-118 - Manual (Page 15)

15
Initial Installation
QUALIFIED INSTALLERS ONLY
These screws will keep the trim tight against the surround. Route the wiring
harness through the hole in the lower right side of the unit marked with an ‘A’
in Figure 20. Connect the wires from the unit to the ON/OFF/THERMOSTAT
switch and the FAN CONTROLLER on the surround panel (see Figure 25).
Wrap the three (3) Wire Ties around the wiring harness to ensure the wires
stays close to the trim (see Figure 21).
IMPORTANT: When replacing the Rheostat (FAN CONTROLLER) or Rocker
Switch (ON/OFF/THERMOSTAT switch), ensure that the wires are captured
behind the surround trim with the Wire Ties.
Option 3 - Cast Iron Faceplate or Bay Door Assembly.
The fan controller is to be installed into the Focus’ control panel but the burner
switch can be installed into the fascia (see Figure 20). To accomplish this,
cut one wire tie so that the wires can be properly routed. Place the orange
and white wires through through the hole in the side of the unit, marked
with an “A” in Figure 20, then along behind the front edge of the fireplace
bottom to the control panel. Use the wire ties provide to bundle and secure
wire. Remove the knob and screw from the fan controller and place the fan
controller through the round hole in the control panel from the back. Tighten
nut onto fan controller from the front of control panel and push on the knob.
The burner switch is pressed into a notch on the edge of the fascia.
Fan controller location
Wiring harness
Burner switch location
A
Figure 20: Component placement.
The fan controller and burner switch are to be installed
into the Focus’ control panel (see Figure 20). Remove the
knob and screw from the fan controller and place the fan
controller through the round hole in the control panel from
the back. Tighten nut onto fan controller from the front of
control panel and push on the knob. The burner switch is
just pushed into place from the front of the control panel.
Route the wiring harness as shown in Figure 20.
Option 2 - Standard Surround Panel.
The standard surround panel comes with the Fan Controller
pre-mounted in the surround panel, and the burner switch
is pressed into a hole in the side top of the trim, therefore,
the set that comes with the unit panel (if used) can be kept
11. Place the assembled surround panel around the stove, align the slots. Push back then down to
engage the surround panel hooks with the slots in the fireplace. Install the decorative fascia or bay
window options to the appliance by aligning the hooks and the slots in the fireplace as seen in the
surround panel installation.
F
AN
C
ONTROLLER
& B
URNER
S
WITCH
I
NSTALLATION
:
The wiring from the power cord to the fan and components should be checked, and corrected if necessary
(refer to Figure 25). The fan controller and burner switch may be installed in one of three places. Keep
the wires away from the bottom of the firebox or any other hot surfaces.
Option 1 - Unit Panel, Cast Iron Faceplate, Bay Door Assembly, or Custom Surround Panel.
Figure 21: Wire ties holding
wires against the trim.
as spare parts. On the right side trim there may be three (3) holes with a Phillips screw and wire tie
installed at each hole (refer to Figure 21). If not, wire ties and an extra screw are supplied with the unit.