Euro-Pro EP136R - Manual (Page 3)

IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, electric shock, or
injury:
• Do not leave the hand vacuum plugged in
when unattended. Unplug the electrical cord
when not in use and before servicing.
• Do not allow to be used as a toy. Close
attention is necessary when used by or near
children, pets or plants.
• Use only as described in this manual. Use
only manufacturer’s recommended
accessories.
• Do not pull cord, use cord as a handle, close
a door on cord, or pull cord around sharp
edges or corners. Keep cord away from
heated surfaces.
• Use only extension cords UL-rated or cUL at
15 amperes. extension cords rated for less
amperage may overheat. Care should be
taken to arrange the cord so that the cord
cannot be pulled or tripped over.
• Turn off all controls as applicable before
unplugging from electrical outlet.
• Do not unplug by pulling on cord. To unplug,
grasp the plug, not the cord.
• Do not handle plug or hand vacuum with wet
hands or operate without shoes.
• Do not put any objects into openings. Do
not use with any opening blocked. Keep free
of dust, lint, hair and anything else that may
reduce air flow.
• Store your appliance indoors in a cool, dry
area.
• Keep your work area well lit.
• Do not immerse the hand vacuum into water
or other liquids.
• Keep end of hose, wands and other
openings away from your face and body.
• Use only on dry surfaces.
• Using improper voltage may result in damage
to the motor and possible injury to the user.
Correct voltage is listed on rating label.
When using your Hand Vacuum, basic safety precautions should always be observed,
including the following:
1. Read all instructions before using your
hand vacuum.
2. Use the system only for its intended use.
3. To protect against a risk of electric shock, do
not immerse any part of the system in water
or other liquids.
4. Never yank cord to disconnect from outlet;
instead, grasp plug and pull to disconnect.
5. Do not allow cord to touch hot surfaces.
6. Do not run appliance over cord.
7. Do not operate the system with a damaged
cord or plug, or if the appliance or any other
part of the system has been dropped or
damaged. To avoid the risk of electric shock,
do not disassemble or attempt to repair the
hand vacuum. Return the system to EURO-
PRO Operating LLC (see warranty) for
examination and repair. Incorrect
re-assembly or repair can cause a risk of
electrical shock or injury to persons when the
hand vacuum is used.
8. Close supervision is necessary for any
appliance being used by or near children.
Do not leave the system unattended while
connected.
9. Keep hair, loose clothing, fingers and all
parts of body away from opening and
moving parts.
10. Do not use to pick up flammable or
combustible liquids such as gasoline or use
in areas where they may be present.
11. Do not pick up anything that is burning or
smoking such as cigarettes, matches or hot
ashes.
12. Use extra care when cleaning on stairs.
13. Do not use the hand vacuum without the
dust cup filter in place.
14. This appliance is intended only for
household use. Follow all user
instructions in this manual.
ORDERING REPLACEMENT FILTERS
TO ORDER REPLACEMENT FILTERS
for Model EP136R
Call: 1 (800) 798-7398
Monday to Friday 8:30 A.M. - 5:00 P.M.
Eastern Standard Time
or
visit our website: www.sharkvac.com
FOR TECHNICAL SUPPORT
for Model EP136R
Call: 1(800) 798-7398
Monday to Friday 8:30 A.M. - 5:00 P.M.
Eastern Standard Time
Please Note
The Dust Cup Filter is washable. It should, however, be replaced every
three months to ensure peak performance of your vacuum.
Both the Pre-Motor and Post Motor Filters are washable. They should
however be replaced every three (3) months to ensure peak performance
of your vacuum.
Important
Make sure that ALL filters are completely dry before re-installing back in
the hand vacuum.
SAVE THESE INSTRUCTIONS
For Household Use Only
WARNING: To reduce the risk of electric shock, this appliance has a polarized
plug (one blade is wider than the other). This plug will fit in a polarized outlet only
one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install the proper outlet. Do not modify
the plug in any way.
Rev. 08/05A 8 1