Blackmagic Design Web Presenter 4K - Manual (Page 6)

Connecting a Monitor
Plug your HDMI television or SDI monitor into one of the monitor outputs. This lets you monitor
your broadcast and observe important status information that updates constantly with your
video stream. For more information on how to use the monitor output, refer to the ‘Using the
Monitor Output’ section.
Connect a monitor to your web presenter’s monitor output
Connecting to a Computer via USB
Connect your Web Presenter to your computer using the USB-C port on the front or rear panel.
These USB ports are used for updating the unit and configuring it with the Blackmagic Web
Presenter Setup utility. Once you have configured your Web Presenter for the first time, you can
then disconnect the unit from the computer.
Connect your Blackmagic Web Presenter to your computer
using the USB port on the front or rear panel
Connecting to the Internet
Connect your Blackmagic Web Presenter to the internet by plugging a network cable from the
‘live stream’ Ethernet port to an internet router or a network switch.
Connect your Blackmagic Web Presenter to your
network via the Ethernet port on the rear panel
6 Getting Started