Electro-Voice Very Compact Full-Range Speaker 3.2 - Manual (Page 2)

Architecture & Engineering Specs:
The loudspeaker shall be a two-way system consisting of two 3.5”
(89mm) low-frequency transducers, a .75” (19mm) high-frequency
transducer, and a frequency-dividing network installed in a vented, line-
array enclosure. The network shall include a passive limiter for both the
low-frequency and high-frequency transducers. The loudspeaker system
shall meet the following performance criteria: Power handling, 150
Watts of EIA RS-426A continuous pink noise (6 dB crest factor); Frequency
response, 85 Hz – 20 kHz (-10 dB from rated sensitivity); Pressure
sensitivity, 87 dB at one watt, 200 Hz – 10 kHz at one meter; Impedance,
8 ohms nominal, 6 ohms minimum. The enclosure shall be molded of
acrylic butyl styrene. The enclosure shall be 9.2” (234mm) high, 5.1”
(127mm) wide, 6.5” (165mm) deep. The finish shall be a paintable black
or white. The grille shall be zinc plated, powder coated for corrosion
resistance, and restrained with a safety leash. The loudspeaker shall be
adjustable over a range of 100° horizontally and 90° vertically. The support
bracket shall be low profile and integral with the enclosure. The system
shall be weather resistant to MIL Spec 810 and IEC 529 IP 34 test
conditions. The surface mount loudspeaker shall be the Electro-Voice®
EVID model 3.2.
U.S.A. and Canada only. For customer orders, contact Customer Service at:
800/392-3497 Fax: 800/955-6831
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
+ 49 9421-706 0 Fax: + 49 9421-706 265
Other International locations. For customer orders, contact Customer Service at:
+ 1 952 884-4051 Fax: + 1 952 887-9212
For warranty repair or service information, contact the Service Repair department at:
800/685-2606
For technical assistance, contact Technical Support at: 866/78AUDIO
Specifications subject to change without notice.
12000 Portland Avenue South, Burnsville, MN 55337
Phone: 952/884-4051, Fax: 952/884-0043
www.electrovoice.com
© Telex Communications, Inc. 12/2005
Part Number 38109-981 Rev E
Beamwidth:
Frequency Response:
Directivity:
9.2
[233.7]
6.5
[165.1]
5.1
[129.5]
1.67
[42.4]
2.5
[63.5]
3.33
[84.7]
1.0
[25.4]
1.38
[34.9]
Ø0.26 x 4
2.75
[69.9]
Side
Wall Plate
Front
Top
Performance Match:
• EVID 12.1 Sub
Available Accessories:
• MA-3 Microphone Stand Mounting Kit for 3.2
• HS-3 Horizontal Mount Desk Stand for 3.2/4.2
• VS-3 Vertical Mount Desk Stand for 3.2
• AB-ZE Array Bracket Kit for 2 or 4 ZX1i or EVID Systems, Black
EVID 3.2 Part Numbers:
301045-001 Black
301045-002 White
301045-003 Black, Transformer
301045-004 White, Transformer
Block Diagram:
INPUT
LPF
HPF
Passive
Limiter +
Dimension Drawings: