LD Systems CURV 500 AVS Portable Array System AV Set with Speaker Cables (Black) - Manual (Page 7)

7
DEUTSCH
ENGLISH
FRANCAIS
ESP
AÑOL
POLSKI
IT
ALIANO
•••
7 POWER LED
Lights up once the system is properly connected to the power mains and switched on.
8 POWER CONNECTOR WITH FUSE HOLDER
IEC power socket with built-in fuse holder. An appropriate power cord is included in the delivery. IMPORTANT INFORMATION: Replace the
fuse only with a fuse corresponding to the operating voltage. Please observe the label on the housing. If the fuse blows repeatedly, please
contact an authorised service centre.
9 POWER ON / OFF
On / Off switch for the power supply of the device.
10 SATELLITE OUT LEFT / RIGHT
Speakon compatible outputs for controlling the LD CURV 500 ® satellites. Up to four LD CURV 500® satellites can be operated at each of the
outputs simultaneously (e.g. for voice and sound). When using a CURV 500 ® ES Entertainer Set as a Mono Set, use the satellite output LEFT
for the control of the LD CURV 500 satellites and the MONO / STEREO (26) on the mixer control panel switch must be pressed down (MONO).
When using a LD CURV 500 ® ES Entertainer Set as a Stereo Set (2 array satellites mounted left and right), or when using the LD CURV 500 ®
AVS A/V Set, use both satellite outputs LEFT and RIGHT to control the LD CURV 500 ® satellites left and right and the MONO / STEREO (26)
switch on the mixer control panel must not be pressed down (STEREO). An incoming stereo audio signal will be output in stereo. The use of
the LD CURV 500 ® PS Power Set as a Stereo Set (or the combination of LD CURV 500 ® ES and LD CURV 500 ® PES) requires the use of the
satellite output LEFT (left) for the control of the LD CURV 500 ® satellite on the left. The LD CURV 500 ® satellite on the right is controlled by
the satellite output of the expansion subwoofer SATELLITE OUT RIGHT.
12
13
14
15
11
17
18
19
20
16 21
22
23
24
25
26
27
28
29
30
31
11 LED CH 1
When a signal is present at the input of channel 1 (CH 1), the LED indicator lights up green; if the LED is red, the channel is operating at the
clipping range. To avoid distortion, reduce the volume level of the volume controller (12) of channel 1.
12 LEVEL CH 1
Volume controller for channel 1 (CH 1). Turning the dial to the right increases the volume and turning it to the left decreases it.
13 EQUALIZER HIGH CH 1
Equalizer high band for channel 1 (CH 1). When turned to the left, levels are lowered, when turned to the right, they are raised. In the centre
position (resting point), the equalizer is inactive.