Enviro EG 33 User Manual
Eg 33 direct vent, Zero clearance
Table of contents
Document Outline
- EG 33 Direct Vent
- OWNERS MANUAL
- FOR SAFE INSTALLATION AND OPERATION OF YOUR “ENVI
- MOBILE HOME
- NOTE:
- Place the unit into the framed opening. Nail or screw the unit to the framing using the nailing flanges provided. MAKE SURE THAT THE UNIT IS LEVEL AND PLUMB BEFORE NAILING OR SCREWING TO THE FRAMING MEMBERS. ALSO INSURE THAT THE BOTTOM OF THE UNIT IS LEV
- Once the unit has been secured, install all venting according to local codes and guidelines and restrictions applied in this manual.
- REQUIRED MANTLE CLEARANCES
- VENT RESTRICTIONS:
- FLUE COLLAR INSTALLATION
- VENT TERMINAL CLEARANCES
- PLANNING YOUR INSTALLATION
- HORIZONTAL INSTALLATION
- Place a bead of Mil-Pac on the outer edge of the inner exhaust pipe (non-flared end). Place a bead of high temperature silicone on the male edge of the outer pipe. Push the pipe sections completely together, then twist-lock one section clockwise approx
- VERTICAL INSTALLATION
- INSTALLATION OF LOGSET and EMBERS
- OPERATING INSTRUCTIONS
- ROUTINE MAINTENANCE and TECHNICAL
- To adjust for high altitude: open the lower louvers, Locate the venturis between the burner and control trays. Loosen the 2 set screws with a long screwdriver and rotate the air shutters to the correct setting.
- TROUBLE SHOOTING
- GAS LINE CONNECTION
- ELECTRICAL