Enviro EG 33 User Manual
Eg 33 direct vent, Zero clearance
SHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY
THIS MANUAL IS PRINTED ON RECYCLED PAPER
EG 33 Direct Vent
ZERO CLEARANCE
By SHERWOOD INDUSTRIES LTD.
an after market permanently located
O W N E R S M A N U A L
This appliance may be installed in
manufactured (mobile) home, where
not prohibited by local codes.
This appliance is only for use with
the type of gas indicated on the
rating plate. This appliance is not
convertible for use with other gases,
unless a certified kit is used
WHAT TO DO IF YOU SMELL GAS
• Open windows
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any
phone in your building.
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call the fire
department.
WARNING
If the information in this manual
is not followed exactly, a fire or
explosion may result causing
property damage, personal
injury or loss of life. Installation
and service must be performed
by a qualified installer, service
agency or the gas supplier.
FOR YOUR SAFETY
Do not store or use gasoline or other Flammable vapors and liquids in the vicinity of
this or any other appliance.
Document Outline
- EG 33 Direct Vent
- OWNERS MANUAL
- FOR SAFE INSTALLATION AND OPERATION OF YOUR “ENVI
- MOBILE HOME
- NOTE:
- Place the unit into the framed opening. Nail or screw the unit to the framing using the nailing flanges provided. MAKE SURE THAT THE UNIT IS LEVEL AND PLUMB BEFORE NAILING OR SCREWING TO THE FRAMING MEMBERS. ALSO INSURE THAT THE BOTTOM OF THE UNIT IS LEV
- Once the unit has been secured, install all venting according to local codes and guidelines and restrictions applied in this manual.
- REQUIRED MANTLE CLEARANCES
- VENT RESTRICTIONS:
- FLUE COLLAR INSTALLATION
- VENT TERMINAL CLEARANCES
- PLANNING YOUR INSTALLATION
- HORIZONTAL INSTALLATION
- Place a bead of Mil-Pac on the outer edge of the inner exhaust pipe (non-flared end). Place a bead of high temperature silicone on the male edge of the outer pipe. Push the pipe sections completely together, then twist-lock one section clockwise approx
- VERTICAL INSTALLATION
- INSTALLATION OF LOGSET and EMBERS
- OPERATING INSTRUCTIONS
- ROUTINE MAINTENANCE and TECHNICAL
- To adjust for high altitude: open the lower louvers, Locate the venturis between the burner and control trays. Loosen the 2 set screws with a long screwdriver and rotate the air shutters to the correct setting.
- TROUBLE SHOOTING
- GAS LINE CONNECTION
- ELECTRICAL