Electrolux EHGT326X - Manual (Page 3)

3
The following symbols will be found in the text to
guide you throughout the Instructions:
Safety Instructions
Step by step instructions for an operation
Hints and Tips
Environmental information
Guide to Use the instructions
1 Rapid Burner - 3,0 kW
2 Auxiliary Burner - 1,0 kW
3 Burner Control Knobs
Contents
Instruction for the User
Description of the appliance
2
1
3
Description of the appliance ......................... 3
Instruction for the User ................................. 3
Cleaning and Maintenance ............................ 4
Guarantee - After Sales Service ................... 5
Technical Data ................................................ 6
Instruction for the Installer ............................ 6
Electrical Connection ..................................... 7
Adaptation to different
types of gas ..................................................... 8
Building In ....................................................... 9
Burner Control Knobs
The hob burner control knobs are situated on the hob front
panel. The symbols on the knobs mean that :
there is no gas supply
there is maximum gas supply / Ignition setting
there is minimum gas supply
Lighting the burners
For easier lighting, proceed before putting a
pan on the pan support.
1. Push the relevant knob down and turn it anti-clockwise
until it reaches the "maximum" position.
2. After lighting the flame, keep the knob pushed down
for about 5 seconds. This will allow the "thermocouple"
(Fig. 1 lett. D) to be heated and the safety device to be
switched off, otherwise the gas supply would be
interrupted.
3. Then, check the flame is regular and adjust it as
required.