Electrolux 76825 - Manual (Page 19)

19
What to do if...
Remedying small faults yourself
If during use of the appliance one of the following error codes is shown
in the multi-display:
– E10 (Problems with the water inflow),
– E20 (Problems with the water outflow),
– E40 (door open),
please consult the following table.
After the error has been remedied, press the START/PAUSE button.
In the event of other errors (E and a number or letter): Switch the ap-
pliance off and then on again. Set the programme again. Press the
START/PAUSE button.
If the error appears again, please contact your local Service Force Cen-
tre, stating the error code.
Problem Possible cause Remedy
Washing machine is not
working.
Mains plug not plugged in
or fuse not working. Connect the plug to a mains
socket. Check fuse.
Loading door not closed
properly. Close loading door - there
should be an audible click.
The START/PAUSE button
has not been pressed for
long enough.
Press the START/PAUSE for a
longer period of time.
The door cannot be
closed. The child safety device has
been activated. Deactivate the child safety
device.
When a button is
pressed, Err appears in
the multi-display. The selected function can-
not be combined with the
programme set.
Select another function.
E40 appears.
The END indicator
flashes 4x, and an
acoustic signal sounds
4x.
The door is not closed prop-
erly. Close the door properly. Re-
start the programme.
E10 appears.
The END indicator
flashes 1x, and an
acoustic signal sounds
1x.
(Problems with water
inflow.) Tap turned off. Turn on the tap.
The filter in the threaded in-
let hose fitting is blocked.
Turn off the tap. Unscrew the
hose, take out the filter and
clean it.
Water tap is furred with
lime scale or is faulty. Check the tap and have it re-
paired, if necessary.