Electrolux 76825 - Manual (Page 15)

15
Starting a programme
1. Check that the tap is turned on.
2. Select a programme.
3. Press the START/PAUSE button. The programme is started, or will start
after the delay timer has counted down.
3
If after pressing the START/PAUSE button E40 flashes in the multi-dis-
play, the END indicator flashes 4 times and at the same time an acous-
tic signal sounds 4 times, the door has not been correctly shut. Push the
door firmly closed and press the START/PAUSE button again.
Programme sequence
• The programme progress display shows the programme step that is
currently being carried out.
• The multi-display shows the estimated time remaining (in minutes)
until the end of the programme.
3
The time remaining can increase or stay the same for a while during the
course of the cycle as the programme adjusts itself to various condi-
tions (e.g. type of washing and quantity, out of balance spin detection,
special rinse cycle, etc.).
Interrupting a programme/adding washing
Interrupting a programme
• A programme can at any time be interrupted by pressing the START/
PAUSE button and resumed by pressing START/PAUSE again.
• To cancel a programme before it has ended, turn the programme se-
lector to OFF. Important: Be careful of water in the appliance.
Adding washing
Washing can be added, as long as the DOOR indicator is illuminated
green.
1. Press the START/PAUSE button. The door can be opened.
2. Close the door and press the START/PAUSE button again. The pro-
gramme will continue.