Electrolux L 75478 FL - Manual (Page 16)

2. Press button
4 , the appliance
starts the countdown of the delay
start.
When the countdown is completed,
the programme starts automatically.
Before you press button 4 to
start the appliance, you can can-
cel or change the set of the de-
lay start.
You cannot set the delay start
with the Steam programme.
CANCEL THE DELAY START
1. Press button
4 . The related indi-
cator flashes.
2. Press button
5 again and again
until the display shows 0’.
3. Press button
4 . The programme
starts.
OPEN THE DOOR
While a programme or the delay start
operates, the appliance door is locked.
To open the appliance door:
1. Press button
4 . The door lock
symbol in the display goes off.
2. Open the appliance door.
3. Close the appliance door and press
button 4 . The programme or the
delay start continues.
If the temperature and level of
the water in the drum are too
high, the door lock symbol stays
on and you cannot open the
door. To open the door do the
steps that follow:
1. Deactivate the appliance.
2. Wait for some minutes.
3. Make sure that no water is in
the drum.
If you deactivate the appliance,
it is necessary to set the pro-
gramme again.
AT THE END OF PROGRAMME
• The appliance stops automatically.
• The acoustic signals operate.
• In the display
comes on.
• The indicator of the Start/Pause but-
ton 4 goes off.
• The door lock symbol goes off.
• Press button
1 to deactivate the ap-
pliance. After five minutes from the
end of the programme, the energy
saving function automatically deacti-
vates the appliance.
When you activate the appli-
ance again, the display show the
end of the last set programme.
Turn the programme knob to
set a new cycle.
• Remove the laundry from the appli-
ance. Make sure that the drum is
empty.
• Keep the door ajar, to prevent mil-
dew and odours.
• Close the water tap.
The washing programme is
completed, but there is water in the
drum:
– The drum turns regularly to prevent
the creases in the laundry.
– The door stays locked.
– You must drain the water to open the
door.
To drain the water:
1. If necessary, decrease the spin
speed.
2. Press the Start/Pause button
4 .
The appliance drain the water and
spin.
3. When the programme is completed
and the door lock symbol goes off,
you can open the door
4. Deactivate the appliance.
16