Enterasys Networks 5H102-48 User Manual
Page 38
Using LANVIEW
4-4
Troubleshooting
TX
(Transmit)
Off
Port enabled, and no
activity.
Should flash green every
two seconds indicating
BPDUs being sent if STA
is enabled and there is a
valid link.
1. Ensure that the STA is enabled and that
there is a valid link.
2. Contact Enterasys Networks for
technical support.
Green
Flashing. Indicates
activity. Rate indicates
data rate.
None.
Amber
Blinking. Port may be
disabled due to Spanning
Tree.
1. Ensure that the port is not disabled.
2. Contact Enterasys Networks for
technical support.
Red
Flashing. Indicates
collision rate.
None, unless there is a high amount of
activity. In this case, check for network
configuration problems or a defective
device.
Solid. Diagnostic failure.
Contact Enterasys Networks for technical
support.
Speed
Off
Port is in 10 Mbps
(10BASE-T).
None.
Green
Solid. Port is in 100 Mbps
(100BASE-TX).
None.
Table 4-1
LANVIEW LEDs (Continued)
LED
Color
State
Recommended Action