Empire Comfort Systems VFSUR30-2 - Manual (Page 15)

25741-0-0309 Page 15
Over time, the rockwool will break down and new rockwool will
need to be placed to recreate the original glowing embers effect.
Remove all old rockwool from the appliance and apply new rock
as described in this section or the log manual.
Note: Only the rockwool supplied with this unit or ordered in
accordance with the Parts List on page 20 should be used on
this burner. See the Parts List on page 20 to order replacement
rockwool.
Placing Lava Rock in front of Burner on fireplace floor
Spread lava rocks on fireplace floor in front and sides of the burner
pan. The lava rocks are for decorative effect and are not required
for fireplace operation.
ATTeNTION: DO NOT PLACE LAVA ROCKS ON BURN-
ER, LOGS OR ROCKWOOL. THE LAVA ROCKS SHOULD
ONLY BE PLACED ON THE FIREPLACE FLOOR.
Flames from the pilot (rear right back side of the pan burner) as
well as the main flame should be visually checked as the log set
is installed.
In normal operation at full rate after 10 to 15 minutes, the flame
appearance should be sets of yellow flames.
NOTe: All flames will be random by design, flame height will
go up and down.
Glowing embers (rockwool) can cover the pan burner in between
the front and middle logs, but very little is necessary to cover this
area. Excess ember material causes the yellow flame to become
orange and stringy. Apply just enough to obtain slow glow and a
gold yellow flame.
Avoid any drafts that alter burner flame patterns. Do not allow fans
to blow directly into fireplace. Do not place a blower inside the
burner area of the firebox. Ceiling fans may create drafts that alter
flame patterns. Sooting and improper burning will result.
During manufacturing, fabricating and shipping, various
components of this appliance are treated with certain oils, films or
bonding agents. These chemicals are not harmful, but may produce
annoying smoke and smells as they are burned off during the initial
operation of the appliance, possibly causing headaches or eye or
lung irritation. This is a normal and temporary occurrence.
The initial break-in operation should last 2-3 hours with the burner
at the highest setting. Provide maximum ventilation by opening
windows or doors to allow odors to dissipate. Any odors remaining
after this initial break-in will be slight and will disappear with
continued use.
figure 12
Placement of the glowing embers (rockwool) is very individual
and light coverage will provide your best effects. We recommend
separation of the rockwool by hand and make your coverage as
light and fluffy as possible.
Place just enough rockwool on the burner to obtain the glow and
a gold, yellow flame.
Do not place rockwool over large ports in rear portion of burner.
Rockwool should not be placed in the area of the pilot assembly.
Application of excess rockwool may adversely affect performance
of the heater.
wArNING: All previously applied rockwool must be removed
prior to reapplication.
PLAceMeNT of GLoWING eMBeRS ANd LAVA RocK
oPeRATIoN INSTRucTIoNS/fLAMe APPeARANce
Note for Burner Port Ignition:
Due to the size of the burner, there may be a small delay before
all burner ports ignite.