Enviro DV42DX - Manual (Page 9)

9
Maintenance And Service
R
outine
m
aintenance
:
At least once a year, run through the following procedures to ensure the system is clean and working
properly. Check the burner to see if all the ports are clear and clean. Check the pilot to make sure it is not
blocked by anything. The pilot flame should be blue with little or no yellow on the tips.
Warning: Clearances must be sufficient to allow access for maintenance and service
Warning: Failure to position the parts in accordance with this manual, or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.
The venting system must be periodically examined; it is recommended the examination is done by a
qualified agency.
c
Leaning
t
he
g
Lass
:
When the fireplace has cooled, remove the face of the fireplace along with the glass. See M
aintenance
a
nd
S
ervice
- g
laSS
d
oor
r
eMoval
. Check the gasket material on the back of the glass, making sure that
it is attached and intact.
During a cold start up, condensation will sometimes form on the glass. This is a normal condition with all
fireplaces. However, this condensation can allow dust and lint to cling to the glass surface. Initial paint
curing of the appliance can leave a slight film behind the glass, a temporary problem. The glass will need
cleaning about two weeks after installation. Use a mild glass cleaner and a soft cloth; abrasive
cleaners will damage the glass and plated surfaces. Depending on the amount of use, the glass
should require cleaning no more than two or three times a season. Do not clean the glass when it is
hot.
c
Leaning
t
he
F
iRebox
:
Remove the logs carefully, as they are very fragile. Gently remove all the embers and rock wool and place
on a paper towel. Vacuum the bottom of the firebox thoroughly. Carefully clean any dust off the logs and
remove any lint from the burner and pilot. At this time, inspect the burner pan for cracking or severe
warping. If a problem is suspected, contact the dealer. Check the logs for deterioration or large amounts
of soot; a small amount on the bottom side of the logs is normal. Replace the logs and embers as in the
l
og
S
et and
e
Mber
i
nStallation
section. If new/more embers and rock wool are required, contact your
nearest ENVIRO dealer.
R
ePLacing
g
Lass
:
The glass in the fireplace is a high temperature ceramic. If the glass is damaged in any way, a factory
replacement is required (see P artS l iSt - c oMPonentS ). Wear gloves when handling the door assembly
with the damaged glass to prevent personal injury. When the glass door assembly is being transported,
it must be wrapped in newsprint and tape and/or a strong plastic bag. Do not operate with the glass
front removed, cracked or broken. Removal and replacement of the glass from the door must be done
by a licensed or qualified service person. The glass must be purchased from an ENVIRO dealer.
No substitute materials are allowed.