Enviro DV42DX - Manual (Page 33)

33
Figure 48: Final Log Set Arrangement with Embers.
Secondary Installation
Figure 49: DV42DX Burning.
Figure 47: Fourth Stage Log Set Installation.
Figure 47: The left log rests on the left pin
and ledge of the back log and the back of the
andiron.
Figure 48: The last log, center log, rests on
the end of the grate and on the ledge cut-out
in the center of the back log.
Once the logs are in place the embers can
be installed. Bags of ceramic fiber embers
and rock wool are provided. The ceramic
fiber comes in chunks that are about 2 inches
(5cm) long. Place them irregularly around the
burner. When there is a sparse but even layer
of embers, spread the rock wool in the same
manner. DO NOT pack the rock wool material
as this could create an unsafe condition. The
pieces should be lightly placed so they don’t
completely block any of the tiny ports. DO
NOT allow any of the embers to rest against
the pilot assembly.
Caution: Use only the type of ember material
supplied with this fireplace. Due to the
irregular size of the ember material, there
may be more than required. Use of other
foreign materials on the burners may create
dangerous conditions.
Figure 49: Refer to this figure when adjusting the venturi and vent restrictor. Make adjustments so that
the flame reaches the approximate height shown
NOTE: While the glass is still
removed, it is recommended that
the gas line be purged by lighting
the pilot.
When lighting the fireplace for
the first time since the log set
and embers have been installed/
replaced, watch for ignition at ALL
the burner ports. If a long delay
is noticed, turn the appliance off
and wait for it to cool down. Then
remove the glass and rearrange the
ember material, making sure none
of the burner ports are blocked.