Envision Peripherals L42H761 - Manual (Page 19)

17
Note: Digital Channel selection
delay
Due to the tuning complexity of
subchannel digital programming, the
time to select and view a digital chan-
nel may take slightly longer than what
the viewer is normally accustomed
to (as compared to analog channel
programs).
Digital channel broadcasts contain
program and system data information
that must be processed before the
channel selection can be displayed.
Channel tuning
Available channels:
- Cable (analog NTSC or digital QAM)
- Terrestrial (analog NTSC or digital ATSC)
If a tuned channel is not yet in the master channel
map, the TV will attempt to tune to the channel
and it will be added to the map.
If the channel is not acquired, a message will ap-
pear reporting that the channel is not available.
When you tune an audio-only digital subchannel, a
display appears with the message Audio only.
Note: Subchannel selections
The new standards employed with digital broadcasting
make it possible to receive multiple program channels
under a single major channel
number which can be selected by pressing the digit
remote control direct-access channel number entry.
Important:
After the installation of the TV channels is completed,
always
make a selection in the Installation menu between
Antenna or
Cable whether you want to watch Antenna TV channels
or Cable TV channels.
If you make use of a signal splitter do not forget to put
the switch in the corresponding position.
Current software info
This menu will appear with your TV software
information.
1 Press the MENU button on the remote control.
2 Use the cursor down to select Installation in
the Settings menu.
3 Using the cursor up/down to choose Current
software info the TV software information is
displayed.
Installation 7 Current software info
Clock
Weak channel installation
Current software info
Reset AV settings
Version:
LT-4226HD-20070410-0
This informs you about the current installed software version of your TV.
Autoprogram
Language
Source
Settings
In the antenna mode, select a channel from the
displayed list of TV channels. Select the “Start”
by pressing red button on the remote control; TV
set will detect the signal.
The signal strength is continuously displayed and
updated as you rotate the antenna.
When strength is enough to identify, user can
store the
channel in the channel list by pressing green but-
ton on the
remote control.
Weak channel installation
Antenna reception for broadcast channels may vary.
If you are
having difficulties acquiring weaker signals, we sug-
gest you use: Weak Signal Installation feature.
Here’s how:
Installation 7 Weak channel install
Clock
Weak channel installation
Current software info
Reset AV settings
2
3
4
5
6
7
8
9
This allows you to maximize the signal quality of weak digital channels
by manually rotating the antenna.
Autoprogram
Language
Source
Settings
English