Electrolux EHG60412 - Manual (Page 8)

PRODUCT DESCRIPTION
2
1
6
5
4
3
1 Semi-rapid burner
2 Semi-rapid burner
3 Control knobs
4 Spark generator button
5 Auxiliary burner
6 Rapid burner
Control knobs
Symbol Description
no gas supply / off
position
Symbol Description
ignition position /
maximum gas supply
minimum gas supply
OPERATING INSTRUCTIONS
Ignition of the burner
Warning! Be very careful when you
use open fire in kitchen environment.
Manufacturer decline any responsibility
in case misuse of the flame
Always light the burner before you put
cookware.
To light the burner:
1. Push and hold the spark generator but-
ton .
2. At the same time turn the control knob
counterclockwise to the maximum posi-
tion
and push it down to light the
burner.
3. Release the spark generator button
when burner lights but keep the control
knob on this position for approximately
5 seconds; this will let thermocouple to
warm up. If not, the gas supply will be
interrupted.
4. Adjust the flame after it is regular.
If after some tries the burner does not
light, check if the crown and its cap are
in correct positions.
3
4
2
1
1 Burner cap
2 Burner crown
3 Ignition candle
4 Thermocouple
Warning! If the burner does not light
after 15 seconds, release the control
knob, turn it into off position and try to
light the burner again after minimum 1
minute.
Important! In the absence of electricity you
can ignite the burner without electrical
device; in this case approach the burner
with a flame, push the relevant knob down
and turn it counter-clockwise to maximum
gas release position.
8 electrolux