beautypg.com

Cleaning, Clean engine and exhaust system, Area – Exmark Turf Tracer S-Series 000 & higher User Manual

Page 40: Remove engine shrouds and clean, Cooling fins, Clean engine and exhaust system area, Remove engine shrouds and clean cooling fins, Clean debris from machine, Clean grass build-up under deck, Waste disposal

background image

Maintenance

Cleaning

Clean Engine and Exhaust
System Area

Service Interval: Before each use or daily

(May be required more
often in dry or dirty
conditions.)

CAUTION

Excessive debris around engine cooling air
intake and exhaust system area can cause engine,
exhaust area, and hydraulic system to overheat
which can create a fire hazard.

Clean all debris from engine and exhaust system
area.

1. Stop engine, wait for all moving parts to stop, and

remove key. Engage parking brake.

2. Clean all debris from rotating engine air intake

screen, around engine shrouding, and exhaust
system area.

3. Wipe up any excessive grease or oil around the

engine and exhaust system area

Remove Engine Shrouds and
Clean Cooling Fins

Service Interval: Every 80 hours

1. Stop engine, wait for all moving parts to stop, and

remove key. Engage parking brake.

2. Remove cooling shrouds from engine and clean

cooling fins. Also clean dust, dirt, and oil from
external surfaces of engine which can cause
improper cooling.

3. Make sure cooling shrouds are properly reinstalled.

Operating the engine without cooling shrouds will
cause engine damage due to overheating.

Clean Debris From Machine

Service Interval: Before each use or daily

1. Stop engine, wait for all moving parts to stop, and

remove key. Engage parking brake.

2. Clean off any oil, debris, or grass build-up on the

machine and cutting deck, especially under deck
belt shields, around the fuel tank, around engine
and exhaust area.

Clean Grass Build-Up Under
Deck

Service Interval: Before each use or daily

1. Stop engine, wait for all moving parts to stop, and

remove key. Engage parking brake.

2. Raise deck to the transport (maximum cutting

height) position. Lift the front of unit and support
unit using jack stands or equivalent support.

3. Clean out any grass build-up from underside of

deck and in discharge chute.

Waste Disposal

Motor Oil Disposal

Engine oil and hydraulic oil are both pollutants to
the environment. Dispose of used oil at a certified
recycling center or according to your state and local
regulations.

Battery Disposal

DANGER

Battery electrolyte contains sulfuric acid, which
is poisonous and can cause severe burns.
Swallowing electrolyte can be fatal or if it touches
skin can cause severe burns.

Wear safety glasses to shield eyes, and rubber
gloves to protect skin and clothing when
handling electrolyte.

Do Not swallow electrolyte.

In the event of an accident, flush with water
and call a doctor immediately.

Federal law states that batteries should not be placed
in the garbage. Management and disposal practices
must be within relevant federal, state, or local laws.

40

This manual is related to the following products: