beautypg.com

Check spark plugs, Check lpg tank, Check lpg fuel delivery system – Exmark Turf Tracer S-Series 000 & higher User Manual

Page 32: Change lpg tank, Maintenance, Warning

background image

Maintenance

Fitting

Locations

Initial

Pumps

Number of Places

Service

Interval

36 inch

Deck

48 inch

Deck

52 inch

Deck

1. Caster
Wheel
Bearings

12

2

2

2

Daily

2. Caster
Pivots

2

2

2

2

Daily

3. PTO
Engagement
Bellcrank

1

1

1

1

40 hours

4. Pump
Drive Idler
Pivot

2

1

1

1

Yearly

5. Clutch
Arm Pivot

1

1

1

1

40 hours

6. Pump
Control
Bearings

2

2

2

2

40 hours

7. Mower
Deck Idler
Pivots

2

1

1

1

Yearly

Number 4 Idler Pivot (Pump Drive) Located

under engine deck.

Number 5 (Clutch Arm Pivot) Located under

engine deck.

3. Lubricate pivot points with a spray penetrating

lubricant as shown in the Spray Lubricant Chart.

Spray Lubricant Chart

Pivot Point

Number of Places

Service Interval

1. PTO Lever

1

40 hours

Check Spark Plugs

Service Interval: Every 160 hours

Remove spark plugs, check condition and reset gaps,
or replace with new plugs. See Engine Owner's
Manual for corrrect spark plug part number. Set
the spark plug gap to .025 inch (.64 mm) for a LPG
powered engine.

Check LPG Tank

Service Interval: Before each use or daily

Check the LPG tank and components for wear or
leaks. Follow all the inspection checks as specified in
the Inspection section in Safety.

Check LPG Fuel Delivery
System

Service Interval: Every 40 hours

Check the entire LPG fuel delivery system for damage
or deterioration. Follow all the inspection checks as
specified in the Inspection section in Safety.

Change LPG Tank

Service Interval: As required

Change the LPG tanks outdoors in a well ventilated
area.

1. Stop the machine on level ground, disengage the

PTO, and engage the parking brake.

2. Close the fuel valve to the tank.

3. Purge all vapors from the hose, by running the

engine until it stops, turn key to “OFF” and
remove it from the ignition.

4. Carefully disconnect the LPG fuel hose.

5. Unlatch the cylinder bracket and remove the tank.

WARNING

Fuel system components are under high
pressure. The use of damaged or improper
components can cause system failure, fuel
leakage, and possible explosion, which may
result in serious injury or death.

Do Not attempt to repair or modify the
valves, fittings, or other tank components.

ONLY use the Exmark approved LPG
tank, fittings, and hoses that were
designed for your mower.

32

This manual is related to the following products: