Electrolux CH 710 - Manual (Page 8)

8
Position the new charcoal fi lter in the
position marked and while holding
the fi lter replace the fi xing hooks as
illustrated.
This appliance can be a possible fi re
hazard if the grease and charcoal
fi lters are not cleaned and replaced as
recommended.
Changing the Light Bulb
Remove the screw fi xing the lighting
support.
Pull the lighting support downwards.
Remove the light bulb by unscrewing it
anticlockwise.
Insert the new light bulb into the lighting
support and screw it clockwise taking care
not to overtighten the light bulb.
If one of the light bulbs has failed to function
check that the lamps is fully screwed into the
lighting support. If lamp failure has occurred then
it should be replaced with a 40W clear cylindrical
lamp with an E14 screw cap.
Replacement fi lters and light bulbs can be
obtained from your local Service Force Centre.