beautypg.com

Routine cleaning and maintenance – Enviro C-10969 User Manual

Page 9

background image

9

ASH PAN AND DOOR GASKETS (weekly)

After extended use the gasketing may come loose. To repair this, glue the gasketing on using high-

temperature fiberglass gasket glue available from your local ENVIRO dealer. This is important to maintain

an airtight assembly.

ASH PAN (2-3 days)

The ash pan is located under the door. To remove the ash pan, simply turn the latch with a large standard

blade screwdriver and pull out towards the front. Dump the ashes into a metal container stored away

from combustibles. Vacuum the ash pan and inside the firebox. CAUTION: BECAUSE THE FLY ASH IS

VERY FINE, THE USE OF A FINE FILTER VACUUM BAG WILL BE REQUIRED TO PREVENT ASH FROM

BEING BLOWN BACK INTO THE ROOM. Please pay special attention that there are no hot ashes in the

firebox or there could be a possibility of a fire hazard inside the vacuum cleaner. Place all hot ashes into

a non-combustible container.

Monitor the ash level every week. Remember that different pellet fuels will have different ash contents.

Ash content is a good indication of fuel efficiency and quality. Refer to “I

NTRODUCTION

- S

AFETY

W

ARNINGS

A

ND

R

ECOMMENDATIONS

” for disposal of ashes. It is important to latch the ashpan tightly whe re-

installing it.

DO NOT PLACE UNBURNED OR RAW PELLET FUEL IN ASH PAN.

HEAT EXCHANGER (weekly)

Clean away any fly ash that may have collected on the heat exchanger by opening the door and brushing

off the fins on the inside of the firebox. As different types of pellets produce different amounts of ash,

cleaning of the fins should be done on a regular basis to enable the unit to run efficiently.

FRESH AIR INTAKE (season)

Inspect periodically to be sure that it is not clogged with any foreign materials.

EXHAUST PASSAGES

(season)

Removal of the firebox backing for bi-annual cleaning (refer to Figure 5):

Routine Cleaning and Maintenance

• Open the door by lifting the handle.

• Remove the burn pot and burn pot liner.

Lubricate all screws with penetrating

oil.

• Remove the two (2) screws that hold each

brick liner retainer in place. Remove side

brick liners by sliding them forward then

out.

• Pull the center panel out.

• Vacuum and clean thoroughly.

Installation of firebox backing:

• Insert center panel with backing.

• Place the two (2) side panels back into the

firebox and reinstall the two (2) retainers

using two (2) screws on each side.

• Replace the burn pot and burn pot liner

• Close the glass door and secure.

Figure 5: Firebox Components Removal.