Philips 70" B-Line 70BFL2114 4K UHD Digital Signage Display - Manual (Page 35)

Mono / Stereo
You can switch the sound of an analogue channel to
Mono or Stereo.
To switch to Mono or Stereo…
1 - Tune to an analoge channel.
2 - Press  OPTIONS , select Mono/Stereo and
press  (right).
3 - Select Mono or Stereo and press OK .
4 - Press  (left) to go back one step or
press  BACK to close the menu.
Programme Info
View programme details
To call up the details of the selected programme…
1 - Tune to the channel.
2 - Press  OPTIONS , select Programme Info and
press OK .
3 - To close this screen, press OK .
11.6
Channel Installation
Install Channels
Antenna/Cable Installation
Search for Channels
You can reinstall all channels and leave all other TV
settings untouched.
If a PIN code is set, you will need to enter this code
before you can reinstall channels.
To Search for Channels…
1 - Press  /  Home >  Settings > Install
channels and press OK .
2 - Select RF Channel Installation and press OK .
3 - Enter your PIN code if necessary.
Select Search for Channels and press OK .
Select Start and press OK.
Select the country where you are now and press OK.
Select
Start and press OK.
Select the type of installation you want, Antenna
(DVB-T) or Cable (DVB-C) and press OK .
Select Next and press OK .
Select the type of channels you want, Digital and
Analogue Channels or Only Digital Channels and
press OK .
Select Next and press OK .
Select Start and press OK to update the digital
channels. This can take a few minutes.
Press
 (left) to go back one step or press  BACK
to close the menu.
Automatic Channel Update
If you receive digital channels, you can set the TV to
automatically update these channels.
Once a day, at 6 AM, the TV updates the channels
and stores new channels. New channels are stored in
the Channels List and are marked with a
 .
Channels without a signal are removed. The TV must
be in standby to automatically update channels. You
can switch off Auromatic Channel Update.
To switch off the automatic update…
1 - Press  /  Home >  Settings > Install
channels and press OK .
2 - Select RF Channel Installation and press OK .
3 - Enter your PIN code if necessary.
4 - Select Automatic Channel Update and
press OK
5 - Select Off and press OK .
6 - Press  (left) to go back one step or
press  BACK to close the menu.
Channel Update Message
When new channels are found or if channels are
updated or removed, a message is shown at TV start
up. To avoid this message to appear after every
channel update, you can switch it off.
To switch off the message…
1 - Press  /  Home >  Settings > Install
channels and press OK .
2 - Select RF Channel Installation and press OK .
3 - Enter your PIN code if necessary.
4 - Select Automatic Channel Update and
press OK
5 - Select Off and press OK .
6 - Press  (left) to go back one step or
press  BACK to close the menu.
In certain countries, the Automatic channel update is
done while watching TV or on any moment when the
TV is in standby.
Digital: Manual Installation
Digital TV channels can be manually installed,
channel by channel.
To install digital channels manually…
1 - Press  /  Home >  Settings > Install
channels and press OK .
2 - Select RF Channel Installation and press OK .
3 - Select Digital: Manual Installation and
press OK .
35