Configuration menu – Philips Q-Line 32BDL3510Q 32" Full HD Digital Signage Display User Manual

Page 27

32BDL3510Q

5.2.6. Configuration menu

Last status

RS232

Last input

4 Sec

PICTURE

SCREEN

AUDIO

TILING

NETWORK

CONFIG

OPTION

Switch on State

Network Control Port

Boot on source

Power LED light

OSD Turn Off

OSD Transparent

Information OSD

Logo

Monitor ID

Monitor Info

Confituration Reset

Switch on state

Select the display status used for the next time you connect
the power cord.
• {Power off} - The display will remain off when the power

cord is connected to a wall outlet.

• {Forced on} - The display will turn on when the power

cord is connected to a wall outlet.

• {Last status} - The display will return to the previous

power status (on/off/standby) when removing and
replacing the power cord.

Network Control Port

Select RS232 support from
• {RS232} – RS232 come from 2.5mm Phonejack
• {LAN} – RS232 come from RJ45

Boot on source

Choose to select source when boot up.

Power LED Light

Select {

Off

} to turn off the indicator.

OSD turn off

Set the period of time the OSD (on-screen display) menu
stays on the screen.
The options are: {5

100} seconds.

OSD Transparency

Adjust OSD transparency.
• {0} - Transparency off.
• {1-100} - Transparency level 1-100

Information OSD

Set the period of time the information OSD is displayed on
the upper right corner of the screen. The information OSD
will display when input signal is changed.
The information OSD will remain on the screen with {Off}
selection.

The options are: {1 - 60} seconds.

Logo

Choose to enable or disable the picture of Logo when turn
on your display.
The options are: {Off} /{On}

Monitor ID

Set the ID number for controlling the display via the RS232
connection.
Each display must have a unique ID number when multiple
sets of this display are connected. Monitor ID number range
is between 1 to 255.
• {1-255} – {Monitor ID}The default setting is 1.
• {1-255} – {Monitor group}The default setting is 1.
• {1-15} – {Tiling matrix}The default setting is 1.
• {Auto ID}
• {Tiling matrix}:
Tiling matrix number range is between 1 to 15. 1 is default
setting.
The {Auto ID} setup function enables setting up {Monitor ID}
of connected machine according to {Tiling matrix} settings.
Example: Tiling matrix sets as 4

Monitor ID

Monitor group

• {Auto ID}: The option are: {Start} / {End}. The default is
{End}.
• Switch to Start option to set up IDs of machines

backward from current one.
Once the setup is completed, the option exits to End
automatically.
To use this function, serial connect all machines with
RS-232 cable and set their Control ports to RS-232 too.

Monitor information

Shows information about your display, including Input
source, Resolution, Model name, SW version, serial number,
operation hours and MAC address.

Monitor information

Model name

Serial NO.

Operation hours

SW Version

MAC address

XXXX

Configuration reset

Reset all settings in

Configuration

menu to the factory preset

values.