Elo TouchSystems 5503L 55" Class Full HD IR Interactive Commercial Display - Manual (Page 30)

User Manual – IDS ET5503L UM600482 Rev. B, page 30 of 37
This equipment complies with the Class A limits for radio noise emissions from digital
apparatus as established by the Radio Interference Regulations of Industrial Canada.
CAN ICES3(A)/NMB3(A)
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est co
nforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes:
(1) l’appareil ne doit pas produire de brouillage;et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Notice to Users in the European Union: Use only the provided power cords and interconnecting cabling provided
with the equipment. Substitution of provided cords and cabling may compromise electrical safety or CE Mark
Certification for emissions or immunity as required by the following standards:
This Information Technology Equipment (ITE) is required to have a CE Mark on the Manufacturer’s label which
means that the equipment has been tested to the following Directives and Standards: This equipment has been
tested to the requirements for the CE Mark as required by EMC Directive 2014/30/ EU as indicated in European
Standard EN 55032 Class A and the Low Voltage Directive 2014/35/EU as indicated in European Standard EN
60950-1.
General Information to all Users: This equipment generates, uses and can radiate radio frequency energy. If not installed and used according to this manual, the
equipment may cause interference with radio and television communications. There is, however, no guarantee that interference will not occur in any particular
installation due to site-specific factors.
1. In order to meet emission and immunity requirements, the user must observe the following:
a. Use only the provided I/O cables to connect this digital device with any computer.
b. To ensure compliance, use only the provided manufacturer’s approved line cord.
c. The user is cautioned that changes or modifications to the equipment not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
2. If this equipment appears to cause interference with radio or television reception, or any other device:
a. Verify as an emission source by turning the equipment off and on. If you determine that the equipment
is causing the interference, try to correct the interference by using one or more of the following
measures:
i. Move the digital device away from the affected receiver.
ii.Reposition (turn) the digital device with respect to the affected receiver.
iii. Reorient the affected receiver’s antenna