Electrolux ESL 66010 - Manual (Page 38)

38 electrolux installation
Water inlet hose with safety valve
After connecting the double-walled
water inlet hose, the safety valve is
next to the tap. Therefore the water
inlet hose is only under pressure
while the water is running. If the water
inlet hose starts to leak during this
operation, the safety valve cuts off the
running water.
Please take care when installing the
water inlet hose:
● The electrical cable for the safety
valve is in the double-walled water
inlet hose. Do not immerse the
water inlet hose or the safety valve
in water.
● If water inlet hose or the safety
valve is damaged, remove the
mains plug immediately.
● A water inlet hose with safety valve
must only be replaced by a
specialist or by the Service Force
Centre.
● Place the water inlet hose in such
a way that it is never higher than
the bottom edge of the safety
valve.
Warning!
Dangerous voltage
117989 83/0en 20-02-2007 17:34 Pagina 38