MACKIE MC-40BT Wireless Over-Ear Headphones - Manual (Page 7)

Owner
’s Manual
7
Owner’s Manual
MC-40BT Features
1
1 2 3 4 5 4
2
3
5
4
First Things First
The MC-40BT wireless headphones were designed
with sound and comfort in mind. That said, for the best
results, the controls shown above should be placed
on the right side of your head.
Warning: The headphones can be loud
and could cause permanent hearing
damage. Even intermediate levels
may be painfully loud. BE CAREFUL!
Always turn the volume all the way down before
putting on the headphones. Then turn it up slowly
as you listen carefully.
1. 1/8" Input Jack
You bought wireless headphones to... well, you know,
go wireless. Cut the cord! Some people just aren’t
ready for that quite yet and we’ve got you covered
here, as well, as this jack allows for a wired connection.
Simply connect the included 1/8" cable from this jack
to a headphone jack of a mixer, phone or anything else
that has a phones out jack.
The Bluetooth signal is killed when
the headphones are “hardwired”
and will remain as such until that
connection has been removed.
2. USB-C Power Connection
This connector is used for charging the MC-40BT
wireless headphones.
It is a standard USB-C power connector.
Connect the USB-C side of the detachable power
cord (included in the packaging) to the MC-40BT
wireless headphones and plug the other end of
the power cord into a standard USB-A connector.
A fully charged set of MC-40BT headphones
can last for up to 30+ hours of continuous usage...
and it takes only three hours for a completely dead
set of MC-40BTs to become fully charged once again.
Please note that the MC-40BT wireless
headphones should not be used while
it’s charging.
3. Status LED
This LED indicates the status of the headphones,
including power, device pairing and more.
• Charging: Status LED illuminates solid red.
• Charged: Status LED illuminates solid blue.
• BT Pairing Mode: Status LED flashes blue and red.
• BT Connected: Status LED slow flashes blue.
• Powered Off: Status LED is off.