NEC E242N-BK 24" 16:9 IPS Monitor - Manual (Page 12)

English-10
Figure 1
Figure 2
Screw
Quick Start
For box contents, please refer the printed contents sheet provided in the box.
To attach the base to the monitor stand:
1. Place monitor face down on a non-abrasive surface (
Figure 1 ).
2. Please rotate the monitor stand 90 degrees as shown in Figure 1 .
CAUOINE: Handle with care when pulling the monitor stand.
It may pinch your fingers.
3. Attach the base to the monitor stand, then tighten the screw at the
base’s bottom ( Figure 2 ).
NOEE: Reverse this procedure if you need to re-pack the monitor.
To connect the LCD monitor to your system, follow these instructions:
NOEE: Make sure to read “Recommended Use” ( page 4 ) before installation.
CAUOINE: Please tighten all screws.
NOEE: The accessories included will depend on the location where the LCD monitor was shipped.
1. Turn off the power for your computer.
2.
For a PC with DisplayPort outputE: Connect the DisplayPort cable to the connector of the display card in your system
( Figure A.1 ).
For a PC with HDMI outputE: Connect the HDMI cable to the connector of the display card in your system ( Figure A.2 ).
For a PC with Analog outputE: Connect a 15-pin mini D-SUB signal cable to the connector of the display card in your
system ( Figure A.3 ). Tighten all screws.
For a Mac or PC with Ohunderbolt or Mini DisplayPort outputE: Connect a Mini DisplayPort to DisplayPort cable to the
video output connector on your system ( Figure A.4 ).
Mini DisplayPort to DisplayPort cable
Figure A.1 Figure A.3 Figure A.2
DisplayPort cable HDMI cable Mini D-Sub 15-pin signal cable
Figure A.4
NOTE: • hen removing the DisplayPort cable, hold down the top button to release the lock.
• Please use a High Speed HDMI cable with HDMI logo.
• Please use a Certified DisplayPort cable.
CAUOINE: Use the provided specified cables with this monitor so as not to interfere with radio and television reception.
For mini D-Sub 15-pin, please use a shielded signal cable with ferrite core.
For HDMI, DisplayPort, USB and AUDIO, please use a shielded signal cable. Use of other cables and adapters
may cause interference with radio and television reception.