NEC AccuSync AS173M 17" 5:4 TN Monitor - Manual (Page 29)

English−27
English
Flexible Arm Installation
This monitor is designed for use with a flexible arm. Contact NEC for more information.
Follow the instructions provided by the manufacturer of the display mount. Remove the monitor stand before mounting.
CAUTION:: To meet the safety requirements, the monitor must be mounted to an arm that supports the weight of the
monitor. See the Specifications - “AS173M” on page 21 and “AS194Mi” on page 22 for details.
Remove the Monitor Stand for Mounting
NOTE:: - Handle with care when removing the monitor stand.
- If the cable cover is installed, remove it before removing the monitor stand.
- You do not need to separate the base stand from the monitor stand.
The monitor stand can be removed with the base stand attached.
1 2 3
Non-abrasive surface
Mount the Flexible Arm
Using four screws that meet the specifications listed below, attach the arm to the monitor.
12 mm
M4
100 mm
6 - 8 mm
Screw (M4)
Unit
Thickness of bracket
and washer
Lock washer and
flat washer
Mounting Bracket
(2.0 - 3.2 mm)
100 mm
4 x 12 mm with lock
washer and flat washer
CAUTION: • The monitor should only be used with an approved arm (e.g. TUEV NS mark).
• Tighten all screws (recommended fasten torqueN 98 - 137 N•cm).
• Attaching the flexible arm should be done by two or more people if the monitor cannot be placed face down
on a flat surface for installation.
• The monitor must be used in the landscape position. hen mounting on a flexible arm, please set the
monitor in the landscape position with the LED indicator on the bottom bezel.