Adjustable monitor stand capability – NEC AccuSync AS173M 17" 5:4 TN Monitor User Manual
Page 16
English−14
3. Attach the cable holder onto the monitor stand (Figure 2).
Figure 2
Cable Holder
Monitor Stand
NOTE:
To prevent damage to the cables, cable holder, and monitor, spread the cables under the cable holder so that the
cables rest side-by-side.
4. Connect the power cord to a power outlet.
NOTE: •
Please refer to the Caution section of this manual for proper selection of the AC power cord (see
).
•
Please make sure that enough power is supplied to the monitor. Please refer to
“Chapter 4 Specifications” on page 21
5. Turn on the monitor by pressing the button and then turn on the computer.
6. hen using the analog (VNA) input, No Touch Auto Adjust automatically adjusts the monitor to optimal settings upon initial
setup.
For further adjustments, use the following OSD controlsN
• AUTO CONTRAST
• AUTO ADJUST
Refer to the
section of this User’s Manual for a full description of these OSD controls.
NOTE:
If you have any problems, please refer to the
section of this User’s Manual.
Adjustable Monitor Stand Capability
Hold the monitor on each side and adjust the tilt as desired.