Lenovo Q27h-20 27" 1440p HDR Monitor - Manual (Page 14)

Adjusting your monitor image
This section describes the user control features used to adjust your monitor image.
Using the direct access controls
The direct access controls can be used when the On Screen Display (OSD) is not displayed.
Table 2-1. Direct access controls
Icon Control Description
1 Up
(1)It is a shortcut for adjusting Brightness while there is
no OSD on the screen.
(2)Press to move lighting-indicator on main menu up to
last one.
(3)Press to increase current values on adjustment bar.
2 Down
(1)It is a shortcut for adjusting Brightness while there is
no OSD on the screen.
(2)Press to move lighting-indicator on main menu down
to next one.
(3)Press to decrease current values on adjustment bar.
3 Left
(1)It is a shortcut for adjusting volume while there is no
OSD on the screen.
(2)Press to move backwards through the sub menus.
(3)Press to decrease current values on adjustment bar
4 Right
(1)It is a shortcut for adjusting volume while there is no
OSD on the screen.
(2)Press to enter sub menu.
(3)Press to increase current values on adjustment bar.
5 Menu/OK
(1)Press to open main menu while there is no OSD on
the screen.
(2)Press to enter next level on main menu or sub menu ,
or move backwards through the sub menus.
(3)Press and hold for 10 seconds to Lock/un-Lock all
menu.
6
Source-
selecting
(1)It is a shortcut for changing input signal while there is
no OSD on the screen or on power-saving mode.
(2)Press to exit from the OSD.
(3)Press and hold for 5 seconds to Enable/Disable the
"DDC/CI" .
7 Power Press to turn On/Off the monitor.
1-9 Q27 h -20 Flat Panel Monitor User’s Guide