English – Acer Nitro XV275K ymipruzx 27" 4K UHD Display User Manual
Page 30
---------------------------------------------------------------------------------------------------------
Note:
1. If Adaptive-sync is “ON”, then the Over Drive selection is set to
“Normal” automatically.
either one of the three settings including: (a) Extreme (b) Normal (c) Off.
2. If Adaptive-sync is “OFF”, then the user can set Over Drive to
7. Refresh rate num: Display the panel’s current refresh rate on the screen.
-----------------------------------------------------------------------------------------------------------
Note:
If Adaptive-sync set "On" you can see the V Frequency to changes
in the OSD.
8.
Ultra-Low Latency
:Set to On to speed up the processing time of the display
switching process.
---------------------------------------------------------------------------------------------------------
Note:
•
Ultra-Low Latency is not support PIP/PBP.
•
Ultra-Low Latency is not support video interlace mode.
•
Ultra-Low Latency is not supports V-Frequency below 48Hz.
•
Ultra-Low Latency is not supports resolutions below 800x600.
•
Ultra-Low Latency is support only Wide Mode = Full and gray out.
Adaptive-sync is “Off”, Ultra-Low Latency can control “On” or “Off”.
•
•
Adaptive-sync is “On”, Ultra-Low Latency is auto setting to "On" and gray out.
•
9. Aim point: Show an Aim point on the screen for shooting games.
---------------------------------------------------------------------------------------------------------
Note:
If hot key meau or main menu is trigger the“Aim point” temporarily closed
English