Event electronic DEH-P8600MP - Manual (Page 59)

1 Use MULTI-CONTROL to select AUX.
The function name tag AUX is highlighted.
2 Press MULTI-CONTROL to turn AUX on.
AUX :ON appears in the display.
# To turn AUX off, press MULTI-CONTROL
again.
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the cars headlights are turned on. You
can turn the dimmer on or off.
1 Use MULTI-CONTROL to select DIM.
The function name tag DIM is highlighted.
2 Press MULTI-CONTROL to turn dimmer
on.
Dimmer :ON appears in the display.
# To turn dimmer off, press MULTI-CONTROL
again.
Adjusting the brightness
Display brightness adjustment lets you adjust
the display for easier viewing when lighting
conditions change.
1 Use MULTI-CONTROL to select BRIGHT.
The function name tag BRIGHT is highlighted.
2 Push MULTI-CONTROL left or right to
adjust the brightness level.
Each pushing MULTI-CONTROL left or right
increases or decreases the brightness level. 0
31 is displayed as the level is increased or
decreased.
Correcting distorted sound
When listening to a CD or other source on
which the recording level is high, setting the
equalizer curve level to high may result in dis-
tortion. You can switch the digital attenuator
to low to reduce distortion.
! Sound quality is better at the high setting
so this setting is usually used.
1 Use MULTI-CONTROL to select D.ATT.
The function name tag D.ATT is highlighted.
2 Press MULTI-CONTROL to select the di-
gital attenuator level.
Pressing MULTI-CONTROL repeatedly will
switch between High (high) and Low (low)
and that status will be displayed.
Switching the sound
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when a call is made or re-
ceived using a cellular telephone connected to
this unit.
! The sound is turned off, MUTE is displayed
and no audio adjustments are possible.
! The sound is attenuated, ATT is displayed
and no audio adjustments, except volume
control, are possible.
! Operation returns to normal when the
phone connection is ended.
1 Use MULTI-CONTROL to select MUTE.
The function name tag MUTE is highlighted.
2 Press MULTI-CONTROL to select the de-
sired setting.
Press MULTI-CONTROL repeatedly to switch
between the following settings:
! 10dB ATT Attenuation
Initial Settings
En
59
English
Section
12