Amp ctl, Power led en, Amp ctl (standby / amplifier control) – SPL Performer S1200 Stereo High Power Amplifier (Black) User Manual
Page 16: Power led, I f r, 2ώ 2 ώ
16
AMP CTL (Standby / Amplifier Control)
AMP CTL (Standby / Amplifier Control)
If you own an SPL device supporting AMP CTL output(s) you can trigger standby and
operation. Therefore connect the AMP CTL output of the SPL device with a mono mini
jack cable to the
of the Performer s1200.
You may also use other 12V trigger controller. The Performer s1200 is in operation
mode when a switching voltage of 12 Volt DC is applied to the AMP CTL input.
As soon as the 12 Volt DC is removed, the Performer s1200 switches back to
standby mode.
Use a mono mini jack cable where the tip is plus and the sleeve is minus.
Power LED
In standby the Power LED is dimly lit.
If the Performer s1200 is in operation, the Power LED lights up brightly.
If the Performer s1200 is off, e.g. the mains switch is off, the Power LED is off.
AM
P CTL/
12V T
RIG
GER
Connect to
AMP CTL output of
SPL Preamplifier/DAC
for remote power on/off
OR
Use 12 V Trigger
AMP CTL/12V TRIGGER
Pin 1 = GND
Pin 2 = Hot (+)
Pin 3 = Cold (–)
TRIM
TRIM
+
+
–
R
R
2
ώ
2
ώ
L
L
–
INPUT SELECT
INP
UT S
ELE
CT
RCA
XLR
SPEAKER OUT
PUT LEFT
XLR WIRING
XLR WIRING
SPEAKER OUTPUT LEFT
INPUT LEFT
INP
UT L
EFT
INPUT RIGHT
INPU
T RIGH
T
SPEAKER OUTPUT RIGHT
Minimum Load
Minimum Load
SPEAKER OUT
PUT RIGHT
• •
•
•
•
•
•
•
•
•
•
•
0 -5.5
-5
-
4.5
-4
-3.5
-3
-2
.5
-
2
-1.
5
-1
-0
.5
• •
•
•
•
•
•
•
•
•
•
•
0 -5.5
-5
-4.5
-4
-3.5
-3
-2.
5
-2
-1
.5
-1
-0
.5
Tip
Sleeve
I F R